If you have been reading about heptapeptide and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2025-10-17. Where a claim depends on a specific study, the study is described rather than over-claimed.
The compound was developed in the 1980s at the Institute of Molecular Genetics in Moscow, where it emerged from research on short ACTH fragments and their effects on the central nervous system. Russian pharmaceutical listings describe it as a nootropic and neuroprotective agent, most often formulated as nasal drops. It is not a marketed medicine in the United States or the European Union, and no pharmacopoeial monograph covers it. Consequently, most published clinical experience with the substance originates from a small number of research centres, mainly in Russia and neighbouring countries.
Pharmacological accounts link semax to melanocortin signalling and to modulation of neurotrophic factor expression, particularly brain-derived neurotrophic factor and nerve growth factor. Much of this evidence comes from rodent studies using intranasal delivery, a route chosen because it allows peptides to reach the central nervous system with limited systemic exposure. Whether the same mechanisms operate in humans at comparable magnitude remains an open question. The precise receptor or receptors responsible for the reported behavioural and neuroprotective effects have not been conclusively identified.
Lyophilised powder is normally kept at -20 °C in a desiccated container, with some suppliers recommending -80 °C for long-term archival storage. Repeated freeze-thaw cycles are the most common cause of avoidable loss, so aliquoting before freezing reduces variability between working sessions. Dissolved peptide is far less stable than the dry solid and is usually prepared fresh or held briefly at 4 °C. Aqueous solutions support both hydrolysis of the backbone and oxidation of the N-terminal methionine, and these two routes dominate degradation under ordinary laboratory conditions.
Identity and purity are confirmed with reversed-phase high-performance liquid chromatography, typically monitored at 214 nanometres where the peptide bond absorbs. Mass spectrometry, either electrospray or MALDI-TOF, verifies molecular mass against the theoretical value and detects truncation or adduct formation. Amino acid analysis and peptide mapping provide additional confirmation when required. The most frequently reported impurities are deletion sequences from incomplete coupling, methionine sulfoxide from oxidation, and dimeric species formed through non-covalent aggregation. Impurity profiles depend strongly on the synthesis and purification route chosen by the producer.
Published research has focused mainly on neurological and cognitive endpoints in animal models, with proposed mechanisms involving brain-derived neurotrophic factor and related signalling pathways. A substantial share of the human data originates from a limited number of research groups, and independent replication in other countries remains sparse. Regulatory status reflects that distribution: the peptide is registered as a medicine in Russia and appears in some neighbouring markets, while elsewhere it is handled as a research chemical without approved therapeutic labelling. Questions about dose-response relationships, long-term effects, and comparability across studies are still open.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C37H51N9O10S | Free acid form of the heptapeptide; depends on terminal groups |
| Molecular mass | About 813.9 g/mol | Average mass used for mass spectrometry confirmation |
| Appearance | White to off-white solid | Supplied as a lyophilised powder; hygroscopic |
| Solubility class | Freely soluble in aqueous media | Water, saline, and phosphate buffers; limited organic solubility |
| Typical storage temperature | -20 degrees Celsius | Long term and dry; short working periods may use 2 to 8 degrees Celsius |
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. Its design combines the ACTH(4-7) core fragment with a C-terminal Pro-Gly-Pro extension, a modification intended to improve stability and prolong activity. The molecule is hydrophilic, carries no lipid chains or glycosylation, and has a theoretical mass just over 810 daltons in its free form. All seven residues are proteinogenic amino acids, so no non-natural building blocks appear in the backbone. A free N-terminal methionine and C-terminal proline define the unmodified parent peptide.
The compound was developed during the 1980s at the Institute of Molecular Genetics in Moscow as part of research on fragments of adrenocorticotropic hormone. Early work examined short ACTH-derived sequences that retained neurotrophic effects while lacking the endocrine activity of the full hormone. Semax entered clinical use in Russia during the 1990s, where it received registration for several neurological indications. Outside that region it remained primarily a laboratory research material rather than an approved therapeutic. English-language literature on it grew more slowly and frequently cited the original Russian studies.
Terminology around the compound varies by source. It appears in catalogues and papers as Semax, as the heptapeptide ACTH(4-7)-Pro-Gly-Pro, and under various alphanumeric laboratory codes used by individual suppliers. These names refer to the same sequence but may imply different salt forms, purity grades, or counter-ions. Peptide databases usually list the free base mass, while product descriptions sometimes report acetate or trifluoroacetate salts with a different formula weight. Because naming conventions for research peptides are not standardised across vendors, checking the declared sequence and measured mass is more reliable than relying on a trade name alone.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Usual interstitial pneumonia (UIP) is a form of lung disease characterized by progressive scarring of both lungs. The scarring (pulmonary fibrosis) involves the pulmonary interstitium (the supporting framework of the lung). UIP is thus classified as a form of interstitial lung disease.
=== External factors === External factors may involve mechanical trauma (physical damage to the body which causes cellular breakdown), electric shock, damage to blood vessels (which may disrupt blood supply to associated tissue), and ischemia. Thermal effects (extremely high or low temperature) can often result in necrosis due to the disruption of cells, especially in bone cells. Necrosis can also result from chemical trauma, with alkaline and acidic compounds causing liquefactive and coagulative necrosis, respectively, in affected tissues. The severity of such cases varies significantly based on multiple factors, including the compound concentration, type of tissue affected, and the extent of chemical exposure. In frostbite, crystals form, increasing the pressure of remaining tissue and fluid causing the cells to burst. Under extreme conditions tissues and cells may die through an unregulated process of membrane and cytosol destruction.
== Sources == Schaffer, Phillip Otto Folin: (1867–1934) (Journal of Nutrition. volume 52, issue 1, pages 3–11. 1954) [1] Edsall, John T. A Biomedical Pioneer (Science, volume 244 (4905), pages 719–720. 1989, doi 10.1126/science.244.4905.719)
Sources: en.wikipedia.org
Serine hydrolases are one of the largest known enzyme classes comprising approximately ~200 enzymes or 1% of the genes in the human proteome. A defining characteristic of these enzymes is the presence of a particular serine at the active site, which is used for the hydrolysis of substrates. The hydrolysis of the ester or peptide bond proceeds in two steps. First, the acyl part of the substrate (the acid part of an ester or the part of a peptide ending in a carboxyl group) is transferred to the serine, making a new ester or amide bond and releasing the other part of the substrate (the alcohol of an ester or the part of the peptide ending in an amino group) is released. Later, in a slower step, the bond between the serine and the acyl group is hydrolyzed by water or hydroxide ion, regenerating free enzyme. Unlike other, non-catalytic, serines, the reactive serine of these hydrolases is typically activated by a proton relay involving a catalytic triad consisting of the serine, an acidic residue (e.g. aspartate or glutamate) and a basic residue (usually histidine), although variations on this mechanism exist. Superfamilies of serine hydrolases includes:
==== Cancer registries ==== Concerned by high breast cancer rates in Vermont, on February 7, 1992, Sanders sponsored the Cancer Registries Amendment Act to establish cancer registries to collect data on cancer. Senator Patrick Leahy introduced a companion bill in the Senate on October 2, 1992. The Senate bill was passed by the House on October 6 and signed into law by President George H. W. Bush on October 24, 1992.
== Operations == Unichem's Formulations manufacturing facilities are located at Goa, Ghaziabad (Uttar Pradesh) and Baddi (Himachal Pradesh). Active Pharmaceutical Ingredient (API) manufacturing facilities are located at Roha (Maharashtra), Pithampur (Madhya Pradesh) and Kolhapur (Maharashtra). Goa, Ghaziabad, Roha, Pithampur and Kolhapur sites are USFDA approved and all the plants are approved from other major health authorities. The Company's facilities have been approved by various International health authorities such as USFDA, UK MHRA, ANVISA (Brazil), COFEPRIS (Mexico), PMDA (Japan), TGA (Australia), SAPHRA (South Africa) and MFDS(Korea), EDQM (European Directorate for the Quality of Medicines), TPD (Canada).
Sources: en.wikipedia.org
It is described as a synthetic analogue of the ACTH(4–10) fragment, a short segment of adrenocorticotropic hormone. Its sequence differs from that fragment and includes two proline residues, which influence stability and behaviour in solution.
It appears in Russian pharmaceutical listings as a nasal formulation, but it is not an authorised medicine in the United States or the European Union. Outside those markets it is normally encountered as a research chemical rather than a prescription product.
Laboratory and animal work points to melanocortin signalling and changes in neurotrophic factor levels, especially brain-derived neurotrophic factor. The exact receptor targets and the degree to which these findings transfer to humans are still unresolved.
Reversed-phase HPLC gives the main purity figure, most often with UV detection near 214 nanometres. Mass spectrometry then confirms the molecular mass. Together the two methods distinguish a correct sequence from a closely related impurity.