intranasal route raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2026-06-21 and is reviewed periodically as new material appears.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It corresponds to the ACTH(4-7) fragment extended at the C-terminus by a Pro-Gly-Pro tripeptide, an addition intended to slow enzymatic breakdown. The molecular formula is C37H51N9O10S and the molecular mass is approximately 814 daltons. In the literature it is often described as an ACTH(4-10) analog, although that label reflects a naming convention as much as a precise structural relationship. The compound was developed in Russia and remains most closely associated with that research tradition.
Laboratory descriptions of the material are consistent across suppliers. It appears as a white to off-white lyophilized powder that dissolves readily in water and in polar organic solvents such as dimethyl sulfoxide. Aqueous solutions are clear and colorless at low concentrations. Because the peptide contains methionine, oxidation at the sulfur atom is a recognized degradation pathway, and handling notes usually call for protected, desiccated storage. Reported purity for research-grade lots is generally above 95 percent as measured by reversed-phase high-performance liquid chromatography.
The compound is registered in Russia as a pharmaceutical product, most commonly formulated as a nasal solution, and has been used in that setting since the 1990s. Outside that jurisdiction it is generally handled as a research chemical rather than an approved medicine. Regulatory status therefore differs sharply between countries, and material sold internationally may not correspond to the Russian pharmaceutical formulation. Documentation with commercial samples is typically limited to a certificate of analysis covering purity and identity, not clinical status or local legal classification.
Pharmacological accounts link semax to melanocortin signalling and to modulation of neurotrophic factor expression, particularly brain-derived neurotrophic factor and nerve growth factor. Much of this evidence comes from rodent studies using intranasal delivery, a route chosen because it allows peptides to reach the central nervous system with limited systemic exposure. Whether the same mechanisms operate in humans at comparable magnitude remains an open question. The precise receptor or receptors responsible for the reported behavioural and neuroprotective effects have not been conclusively identified.
Clinical reports describe use in ischaemic stroke, transient ischaemic attack, optic nerve conditions, and cognitive complaints, but most of these studies are small and were conducted in a single region. Systematic reviews have generally described the evidence base as limited in size and variable in methodological quality. Randomised controlled data suitable for international regulatory assessment are scarce. As a result, major treatment guidelines outside Russia do not include the peptide, and interest in it remains largely research-driven rather than routine clinical.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It is described in the literature as an analogue of the ACTH(4–10) fragment, a short N-terminal portion of adrenocorticotropic hormone that retains some neurotropic activity without the full hormonal effects of the parent peptide. The molecule carries a methionine residue at the N-terminus and two proline residues near the C-terminus, features that shape both its interactions with receptor systems and its chemical stability. The free peptide corresponds to the formula C37H51N9O10S and a molecular mass near 813.9 Da.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C37H51N9O10S | Contains one methionine sulfur atom |
| Molecular mass | Approximately 814 Da | Consistent with a seven-residue peptide |
| Appearance | White to off-white powder | Typical lyophilized form |
| Solubility | Freely soluble in water | Also soluble in dimethyl sulfoxide |
| Typical storage | -20 °C, desiccated | Limits methionine oxidation |
Regulatory status differs sharply between jurisdictions. In Russia the peptide is registered as a prescription nasal preparation, while agencies such as the United States Food and Drug Administration have not approved it for any indication. Products sold elsewhere are typically labeled for laboratory research only, and such labels shift responsibility for safe handling to the purchaser. Because the same name covers pharmaceutical-grade nasal drops and bulk research powder, identity and purity documentation becomes the main practical concern when comparing sources.
Semax is a synthetic seven-amino-acid peptide whose sequence extends the ACTH(4-10) fragment with a C-terminal proline-glycine-proline tripeptide. The commonly cited sequence is Met-Glu-His-Phe-Pro-Gly-Pro, giving a molecular formula near C37H51N9O10S and a molecular weight close to 813.9 g/mol. It belongs to the broader class of synthetic ACTH fragments studied for central nervous system effects rather than for adrenal steroid stimulation. In practice the material appears as a lyophilized white powder for laboratory work or as a dilute saline solution in clinical settings.
Development is attributed to researchers at the Institute of Molecular Genetics in Moscow during the early 1980s, building on earlier Soviet work with ACTH fragments. Russian regulatory approval followed for intranasal use, and the compound has remained commercially available there for decades. Most published human data originate from Russian and, later, some Eastern European clinical reports, which are not always accessible in English translation. Outside that region the material is generally handled as a research chemical rather than a licensed medicine.
Development took place during the 1980s at institutes of the Russian Academy of Sciences, where peptide fragments of ACTH were screened for cognitive and neuroprotective effects. The compound received regulatory approval in Russia as a nasal preparation, marketed for conditions such as ischemic stroke, transient ischemic attacks, and optic nerve disorders. Registration in other countries has not followed. Most published clinical reports originate from a small number of Russian research groups, and independent replication outside that setting remains limited. The regulatory status therefore differs sharply between Russia and the rest of the world.
Laboratory work points toward modulation of neurotrophic signaling, particularly expression of brain-derived neurotrophic factor and nerve growth factor in hippocampal tissue. Studies also describe effects on monoamine turnover, inflammatory mediators, and oxidative markers. These observations come mainly from animal models and cultured cells, so the causal chain in humans is not firmly established. Whether the reported molecular changes translate into measurable clinical benefit is an open question. Reviews generally present the mechanism as plausible rather than demonstrated.
=== Earliest forms of cooling === The seasonal harvesting of snow and ice is an ancient practice estimated to have begun earlier than 1000 BC. A Chinese collection of lyrics from this time period known as the Shijing, describes religious ceremonies for filling and emptying ice cellars. However, little is known about the construction of these ice cellars or the purpose of the ice. Tang dynasty (618 AD) used saltpetre scraped from walls to produce ice in summer. The next ancient society to record the harvesting of ice may have been the Jews in the book of Proverbs, which reads, "As the cold of snow in the time of harvest, so is a faithful messenger to them who sent him." Historians have interpreted this to mean that the Jews used ice to cool beverages rather than to preserve food. Other ancient cultures such as the Greeks and the Romans dug large snow pits insulated with grass, chaff, or branches of trees as cold storage. Like the Jews, the Greeks and Romans did not use ice and snow to preserve food, but primarily as a means to cool beverages. Egyptians cooled water by evaporation in shallow earthen jars on the roofs of their houses at night. The ancient people of India used this same concept to produce ice. The Persians stored ice in a pit called a Yakhchal and may have been the first group of people to use cold storage to preserve food. In the Australian outback before a reliable electricity supply was available many farmers used a Coolgardie safe, consisting of a box frame with hessian (burlap) sides soaked in water.
=== Removal and recovery of polar organics from aqueous streams === Some of King's research has dealt with the removal and recovery of polar organic substances from aqueous streams in two contexts. Research on removal of pollutants by solvent extraction was supported by the U. S. Environmental Protection Agency. He later turned to the use of solvent extraction and adsorption, with and without chemical complexation, for recovery of carboxylic acids, glycols and alcohols from aqueous process streams, such as occur in the manufacture of these chemicals from biomass by fermentation. Much of this work also dealt with novel methods of regeneration of the extractants or adsorbents. The research was sponsored by the U. S. Department of Energy through the Lawrence Berkeley National Laboratory.
Certain inks, coatings, and adhesives are formulated with photoinitiators and resins. When exposed to UV light, polymerization occurs, and so the adhesives harden or cure, usually within a few seconds. Applications include glass and plastic bonding, optical fiber coatings, the coating of flooring, UV coating and paper finishes in offset printing, dental fillings, hydrophobic light-activated adhesive, and decorative fingernail "gels". UV sources for UV curing applications include UV lamps, UV LEDs, and excimer flash lamps. Fast processes such as flexo or offset printing require high-intensity light focused via reflectors onto a moving substrate and medium so high-pressure Hg (mercury) or Fe (iron, doped)-based bulbs are used, energized with electric arcs or microwaves. Lower-power fluorescent lamps and LEDs can be used for static applications. Small high-pressure lamps can have light focused and transmitted to the work area via liquid-filled or fiber-optic light guides. The impact of UV on polymers is used for modification of the (roughness and hydrophobicity) of polymer surfaces. For example, a poly(methyl methacrylate) surface can be smoothed by vacuum ultraviolet. UV radiation is useful in preparing low-surface-energy polymers for adhesives. Polymers exposed to UV will oxidize, thus raising the surface energy of the polymer. Once the surface energy of the polymer has been raised, the bond between the adhesive and the polymer is stronger.
=== Sportspeople === Cyclist and Olympic gold medalist Anna Meares said "Unfair, unsafe – I just don't think this is the right way to go about sport." Cyclist Joseph M. Papp, suspended for doping in 2006, referred to a 1988 Weekend Update skit, saying: "I don't think you'd actually see guys tearing their arms off ... A doping free-for-all just invites the most ambitious person to be the most reckless person, and to take the most drugs possible without literally killing themselves." Badminton player Susan Egelstaff stated, "It cannot, and will not work. The danger is massive." Swimmer and Olympic gold medalist Leisel Jones stated that while she would not participate herself due to the risks, she'd be interested in how fast people could get with doping, saying: "If this clears out people who ... are doing illegal things in sport, if that clears them out our clean sport, that would be wonderful." Swimmer and Olympic gold medalist Libby Trickett said it was understandable TEG would attract fascination and interest, and that "I really, really, really hope that it's done under medical supervision because that's the only way I can kind of justify in my head something like this to go ahead." Olympic swimmer Mark Foster expressed similar views, noting also that money has attraction.
Sources: en.wikipedia.org
Indian Coffee House is a chain of restaurants run by a series of worker cooperative societies. The India Coffee House chain was started by the Coffee Cess Committee in 1936, The idea of Coffee House was formed since native Indians were not allowed into Coffee Houses which were mainly allowed only for Europeans. The first outlet of Indian Coffee House was opened in Bombay. By the 1940's there were 50 coffee houses across the country. To run the coffee houses in India, there are 13 cooperative societies.
=== Micro-mechanical cleavage === The most famous, clean and rather straightforward method of isolating graphene sheets, called micro-mechanical cleavage or more colloquially called the scotch tape method, was introduced by Novoselov et al. in 2004, which uses adhesive tape to mechanically cleave high-quality graphite crystals into successively thinner platelets. Other methods do exist like exfoliation.
The surgeon designs the paramedian forehead flap from a custom-fabricated three-dimensional metal foil template derived from the measures of the nasal defect to be corrected. Using an ultrasonic scanner, the flap-pedicle is centre-aligned upon the Doppler signal of the supraorbital artery. Afterwards, the distal one-half of the flap is dissected and thinned to the subdermal plexus.
=== Active site === Histidinol is held inside the active site thanks to a zinc ion, but the zinc ion does not participate in the catalysis otherwise. The zinc ion is held in place by His262, Gln259, Asp360 and His419 (which, in homodimeric histidinol dehydrogenases, comes from the other monomer). Histidinol itself is held in place by His327 and His367 from one moment unit and Glu414 from the other monomer unit. A Cys residue has been implicated in the catalytic mechanism of the second oxidative step. However, according to newer studies with histidinol dehydrogenase from E. coli, the mechanism is catalyzed by four bases, B1-B4. His327 acts as the first base, deprotonating histidinol's hydroxyl group. Concomitantly, hydride is abstracted from histidinol by NAD+, which is then exchanged for a second NAD+ molecule. Glu325 acts as the second base, deprotonating a molecule of water, which then attacks histidinol. At the same time, His327 (now protonated) donates a proton to the aldehydic oxygen, which results in a gem-diol. After then, His327 again deprotonates one of the hydroxyl groups and NAD+ abstracts a proton from the reactive carbon atom. This series of steps oxidizes the hydroxyl group to a carboxylic acid.
=== Stable interactions vs. transient interactions === Stable interactions involve proteins that interact for a long time, taking part of permanent complexes as subunits, in order to carry out functional roles. These are usually the case of homo-oligomers (e.g. cytochrome c), and some hetero-oligomeric proteins, as the subunits of ATPase. On the other hand, a protein may interact briefly and in a reversible manner with other proteins in only certain cellular contexts – cell type, cell cycle stage, external factors, presence of other binding proteins, etc. – as it happens with most of the proteins involved in biochemical cascades. These are called transient interactions. For example, some G protein–coupled receptors only transiently bind to Gi/o proteins when they are activated by extracellular ligands, while some Gq-coupled receptors, such as muscarinic receptor M3, pre-couple with Gq proteins prior to the receptor-ligand binding. Interactions between intrinsically disordered protein regions to globular protein domains (i.e. MoRFs) are transient interactions.
Sources: en.wikipedia.org
It is registered as a pharmaceutical product in Russia, where it is typically supplied as a nasal solution. In most other countries it is not an approved drug and is traded as a research chemical instead. Approval status depends entirely on the jurisdiction involved.
Most published work uses intranasal administration, matching the route of the registered Russian formulation. Some animal experiments use intravenous or intraperitoneal injection. The route matters because the intact peptide is cleared rapidly from blood, so exposure differs between methods.
A purity value describes the share of the powder accounted for by the target peptide, usually by high-performance liquid chromatography. It does not confirm that the sequence is correct, which requires mass spectrometry or amino acid analysis. Purity and identity are separate checks.
It is described as a synthetic analogue of the ACTH(4–10) fragment, a short segment of adrenocorticotropic hormone. Its sequence differs from that fragment and includes two proline residues, which influence stability and behaviour in solution.