Everything below concerns methionine sulfoxide. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2025-08-22. Numbers and descriptions here follow the published literature rather than marketing material.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. Its design combines the ACTH(4-7) core fragment with a C-terminal Pro-Gly-Pro extension, a modification intended to improve stability and prolong activity. The molecule is hydrophilic, carries no lipid chains or glycosylation, and has a theoretical mass just over 810 daltons in its free form. All seven residues are proteinogenic amino acids, so no non-natural building blocks appear in the backbone. A free N-terminal methionine and C-terminal proline define the unmodified parent peptide.
The compound was developed during the 1980s at the Institute of Molecular Genetics in Moscow as part of research on fragments of adrenocorticotropic hormone. Early work examined short ACTH-derived sequences that retained neurotrophic effects while lacking the endocrine activity of the full hormone. Semax entered clinical use in Russia during the 1990s, where it received registration for several neurological indications. Outside that region it remained primarily a laboratory research material rather than an approved therapeutic. English-language literature on it grew more slowly and frequently cited the original Russian studies.
Terminology around the compound varies by source. It appears in catalogues and papers as Semax, as the heptapeptide ACTH(4-7)-Pro-Gly-Pro, and under various alphanumeric laboratory codes used by individual suppliers. These names refer to the same sequence but may imply different salt forms, purity grades, or counter-ions. Peptide databases usually list the free base mass, while product descriptions sometimes report acetate or trifluoroacetate salts with a different formula weight. Because naming conventions for research peptides are not standardised across vendors, checking the declared sequence and measured mass is more reliable than relying on a trade name alone.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Identity and purity are confirmed with reversed-phase high-performance liquid chromatography, typically monitored at 214 nanometres where the peptide bond absorbs. Mass spectrometry, either electrospray or MALDI-TOF, verifies molecular mass against the theoretical value and detects truncation or adduct formation. Amino acid analysis and peptide mapping provide additional confirmation when required. The most frequently reported impurities are deletion sequences from incomplete coupling, methionine sulfoxide from oxidation, and dimeric species formed through non-covalent aggregation. Impurity profiles depend strongly on the synthesis and purification route chosen by the producer.
Published research has focused mainly on neurological and cognitive endpoints in animal models, with proposed mechanisms involving brain-derived neurotrophic factor and related signalling pathways. A substantial share of the human data originates from a limited number of research groups, and independent replication in other countries remains sparse. Regulatory status reflects that distribution: the peptide is registered as a medicine in Russia and appears in some neighbouring markets, while elsewhere it is handled as a research chemical without approved therapeutic labelling. Questions about dose-response relationships, long-term effects, and comparability across studies are still open.
Lyophilised powder is normally kept at -20 °C in a desiccated container, with some suppliers recommending -80 °C for long-term archival storage. Repeated freeze-thaw cycles are the most common cause of avoidable loss, so aliquoting before freezing reduces variability between working sessions. Dissolved peptide is far less stable than the dry solid and is usually prepared fresh or held briefly at 4 °C. Aqueous solutions support both hydrolysis of the backbone and oxidation of the N-terminal methionine, and these two routes dominate degradation under ordinary laboratory conditions.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It is described in the literature as an analogue of the ACTH(4–10) fragment, a short N-terminal portion of adrenocorticotropic hormone that retains some neurotropic activity without the full hormonal effects of the parent peptide. The molecule carries a methionine residue at the N-terminus and two proline residues near the C-terminus, features that shape both its interactions with receptor systems and its chemical stability. The free peptide corresponds to the formula C37H51N9O10S and a molecular mass near 813.9 Da.
The compound was developed in the 1980s at the Institute of Molecular Genetics in Moscow, where it emerged from research on short ACTH fragments and their effects on the central nervous system. Russian pharmaceutical listings describe it as a nootropic and neuroprotective agent, most often formulated as nasal drops. It is not a marketed medicine in the United States or the European Union, and no pharmacopoeial monograph covers it. Consequently, most published clinical experience with the substance originates from a small number of research centres, mainly in Russia and neighbouring countries.
Pharmacological accounts link semax to melanocortin signalling and to modulation of neurotrophic factor expression, particularly brain-derived neurotrophic factor and nerve growth factor. Much of this evidence comes from rodent studies using intranasal delivery, a route chosen because it allows peptides to reach the central nervous system with limited systemic exposure. Whether the same mechanisms operate in humans at comparable magnitude remains an open question. The precise receptor or receptors responsible for the reported behavioural and neuroprotective effects have not been conclusively identified.
Purity assessment relies mainly on reversed-phase high-performance liquid chromatography, which separates the target heptapeptide from truncated sequences, deletion analogues, and oxidised forms. Mass spectrometry, usually coupled to liquid chromatography, confirms identity through the expected molecular ion and reveals modifications such as methionine sulfoxide formation. Amino acid analysis can verify composition, and tandem mass spectrometry supports sequence confirmation. Ultraviolet detection near 254 to 280 nanometres is convenient because the phenylalanine and histidine residues absorb in that region. Nuclear magnetic resonance is rarely used for routine release testing.
Common degradation pathways include oxidation of the methionine side chain, hydrolysis of the peptide backbone, and aggregation under unfavourable pH or concentration. Stability studies typically monitor the main peak by chromatography and report total related substances as a percentage. Because no official monograph exists, acceptance criteria vary between laboratories, and reported purity values are not directly comparable across suppliers. Analysts therefore document the method, column, and detection wavelength alongside each result, and open questions remain about how much biological activity the oxidised forms retain.
They are used in expansive cements, in ultra-high early strength cements, and in "low-energy" cements. Hydration produces ettringite, and specialized physical properties (such as expansion or rapid reaction) are obtained by adjustment of the availability of calcium and sulfate ions. Their use as a low-energy alternative to Portland cement has been pioneered in China, where several million tonnes per year are produced. Energy requirements are lower because of the lower kiln temperatures required for reaction, and the lower amount of limestone (which must be endothermically decarbonated) in the mix. In addition, the lower limestone content and lower fuel consumption leads to a CO2 emission around half that associated with Portland clinker. However, SO2 emissions are usually significantly higher. "Natural" cements corresponding to certain cements of the pre-Portland era, are produced by burning argillaceous limestones at moderate temperatures. The level of clay components in the limestone (around 30–35%) is such that large amounts of belite (the low-early strength, high-late strength mineral in Portland cement) are formed without the formation of excessive amounts of free lime. As with any natural material, such cements have highly variable properties. Geopolymer cements are made from mixtures of water-soluble alkali metal silicates, and aluminosilicate mineral powders such as fly ash and metakaolin. Polymer cements are made from organic chemicals that polymerise. Producers often use thermoset materials.
Medazepam is a drug that is a benzodiazepine derivative. It possesses anxiolytic, anticonvulsant, sedative, and skeletal muscle relaxant properties. It is known by the following brand names: Azepamid, Nobrium, Tranquirax (mixed with bevonium), Rudotel, Raporan, Ansilan and Mezapam. Medazepam is a long-acting benzodiazepine drug. The half-life of medazepam is 36–200 hours.
According to Historian of Art Benjamin Rowland, the portraits in Kizil show "that the Tocharians were European rather than Mongol in appearance, with light complexions, blue eyes, and blond or reddish hair, and the costumes of the knights and their ladies have haunting suggestions of the chivalric age of the West". The Chinese named Kuchean kings by adding the prefix "白", meaning "white", probably pointing to the fair complexion of the Kucheans. The Chinese Monk Xuanzang in 645 CE, noted that "they clothe themselves with ornamented garments of silk and embroidery". This cave also shows Central Asian traders encountering various dangers on their way, such as being lost in the dark, and being saved by the Dragon-King Mabi. Another is the story of the good merchant Sabu (萨缚), who, in order to show the way to a party of 500 merchants lost in the darkness, puts his own arms on fire to use them as torches, and successfully rescues them. The story appears in numerous paintings, in which the merchants are in Central Asian garb and accompanied by camels, and Sab has the attributes of a Bodhisattva. Cave 17 is contemporary with the earliest decorated Mogao Caves near Dunhuang (caves 268, 272 and 275), which were built and decorated by the Northern Liang between 419 and 439 CE, before the invasion of the Northern Wei. They have many stylistic characteristics in common.
Sources: en.wikipedia.org
Shut-down separator (for overheating) Tear-away tab (for internal pressure relief) Vent (pressure relief in case of severe outgassing) Thermal interrupt (overcurrent/overcharging/environmental exposure) These features are required because the negative electrode produces heat during use, while the positive electrode may produce oxygen. However, these additional devices occupy space inside the cells, add points of failure, and may irreversibly disable the cell when activated. Further, these features increase costs compared to nickel metal hydride batteries, which require only a hydrogen/oxygen recombination device and a back-up pressure valve. Contaminants inside the cells can defeat these safety devices. Also, these features cannot be applied to all kinds of cells; prismatic high-current cells cannot be equipped with a vent or thermal interrupt. High-current cells must not produce excessive heat or oxygen, lest there be a failure, possibly violent. Instead, they must be equipped with internal thermal fuses which act before the anode and cathode reach their thermal limits. Replacing the lithium cobalt oxide positive electrode material with a lithium metal phosphate such as lithium iron phosphate (LFP) improves cycle counts, shelf life and safety, but lowers capacity. As of 2006, these safer lithium-ion batteries were mainly used in electric cars and other large-capacity battery applications, where safety is critical. In 2016, an LFP-based energy storage system was chosen to be installed in Paiyun Lodge on Mt.Jade (Yushan) (the highest lodge in Taiwan).
About half of all cases are inherited from a parent who has the condition. The condition is inherited in an autosomal dominant pattern, which means only one copy of the altered gene is necessary to cause the disorder. The other half of cases occur in patients whose families have no history of the disorder. These sporadic cases are caused by new mutations in one copy of the COL3A1 gene. The protein determined by the COL3A1 gene is used to assemble larger type III collagen molecules, found mostly in skin, blood vessels, and internal organs. When the structure or production of type III collagen is altered by a mutation in the COL3A1 gene, collagen fibrils cannot be assembled properly in these tissues, which causes the symptoms of Ehlers-Danlos syndrome.
Cryoneurolysis, also referred to as cryoanalgesia, is a medical procedure that temporarily blocks nerve conduction along peripheral nerve pathways. The procedure, which inserts a small probe to freeze the target nerve, can facilitate complete regeneration of the structure and function of the affected nerve. Cryoneurolysis has been used to treat a variety of painful conditions.
In the kinetic-molecular picture, a non-zero bulk viscosity arises in gases whenever there are non-negligible relaxational timescales governing the exchange of energy between the translational energy of molecules and their internal energy, e.g. rotational and vibrational. As such, the bulk viscosity is
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
It is a synthetic seven-amino-acid peptide built from the ACTH(4-7) sequence plus a Pro-Gly-Pro tail. It belongs to the family of short ACTH fragments studied for nervous-system effects. Its backbone contains only standard amino acids.