The short version of RP-HPLC fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2025-12-29. Anything still debated is marked as such rather than presented as settled.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Solid material is normally kept at minus 20 degrees Celsius in a sealed, desiccated container. Reconstituted solutions are less stable and are usually divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of activity. Light exposure is minimized by using amber glassware or foil wrapping. Published stability data for this peptide are sparse, so recommended storage conditions rest mainly on general practice for short synthetic peptides rather than on dedicated study.
Identity and purity are commonly assessed by reversed-phase high-performance liquid chromatography, with ultraviolet detection near 214 nanometers for the peptide backbone. Mass spectrometry, either electrospray or matrix-assisted laser desorption, confirms molecular mass and detects truncation or modification products. Amino acid analysis can verify composition. Because the sequence contains no strongly absorbing aromatic residue apart from phenylalanine, detection wavelengths are chosen carefully. Purity values above 95 percent are typical for research-grade material.
Quality documentation for research-grade peptide usually includes a certificate of analysis stating purity, identity, and residual counterion content. Batch-to-batch variation in purity and salt form is a recognized issue, and comparisons across suppliers require attention to the exact counterion, for example acetate versus trifluoroacetate. Sequence verification by tandem mass spectrometry provides stronger evidence than a single mass measurement. For any study reporting biological results, the analytical method and the measured purity should be stated explicitly. Independent verification of supplier claims is considered good practice.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
稳定性主要由水解与氧化两条路径支配。肽键在中性或弱酸性条件下相对稳定，遇到强碱或长时间高温则明显断裂；甲硫氨酸侧链容易被氧化成亚砜，使主峰前移并拉低实际含量。金属离子、光照和反复冻融会进一步促进降解或聚集。冻干粉在低温避光条件下可存放较长时间，配制后的水溶液通常需要冷藏并尽快用完。
纯度评估以反相高效液相色谱为主，通过主峰面积百分比给出粗略结果，再配合电喷雾质谱核对分子量。氨基酸分析可验证组成比例，手性色谱或毛细管电泳用于检查残基构型。常见杂质包括缺失序列的短肽、氧化产物与二聚体。由于多数市售品不附带完整检验报告，独立第三方检测常被用来核实标称值。
=== Contract research organizations === Contract research organizations (CROs) provide services to the life science industries along product development. There are more than 2000 CROs operating worldwide, representing revenues of more than $20 billion. There is a key difference between "Product" and "Patient" CROs. Whereas the production sites of CMOs are multipurpose plants, allowing for the production of tens to hundreds of tons of fine chemicals, the work places of patient CROs are the test persons for the clinical trials, and the work places of product CROs are the laboratory benches. Major customers for CRO services are the large global pharmaceutical companies. Half a dozen companies (Pfizer, GlaxoSmithKline, Sanofi-Aventis, AstraZeneca, Johnson & Johnson, and Merck & Co.) alone absorb about one third of all CRO spending. Similarly to CMOs, biotech start-up CROS, with their dichotomy between ambitious drug development programs and limited resources, are the second most promising prospects. Product CROs primarily provide sample preparation, process research and development services. Pilot plants, which produce 100 kg quantities, are combinations of development CROs and CMOs, and ae part of the arsenal of both types of enterprise. Tere are more 100 Product CROs. Most of them are privately held and have revenues of $10–$20 million per year or less, adding up to a total business in the range of $1.5-$2 billion. Examples include:
These procedures aim to inject bio-compatible material (perianal injectable bulking agents, also termed sphincter bulking agents or biomaterial injectables) into the walls of the anal canal, in order to bulk out these tissues. This may bring the walls of the anal canal into tighter contact, raising the resting pressure, creating more of a barrier to the loss of stool, and thereby reducing fecal incontinence. This procedure has many advantages over more invasive surgery, since there are rarely any serious complications.
=== Hearing loss === Alport syndrome can also cause hearing loss although some patients are not affected. Hearing in Alport syndrome patients is normal at birth. Hearing loss in affected patients develops progressively, usually at the stage when kidney function is normal, but there is substantial proteinuria. However, in some patients, hearing loss is only noted after kidney function has been lost. Characteristically the early changes are reduced ability to hear high-frequency sounds, sensorineural deafness. This becomes more severe and affects lower frequencies too. Hearing loss is not usually complete in Alport syndrome; good communication is almost always possible with the use of hearing aids.
Sources: en.wikipedia.org
=== Chinese Civil War: relations with Nationalists and Communists === Liu Wenhui's relationship with the Nationalist government continued to be one of grudging acceptance due to the fact that Xikang was too far from the central government in Nanjing to reliably influence or coerce. It is also believed by historian Kim Hee-shin that Chiang tolerated Liu's presence in Xikang to prevent the Sichuan warlord Liu Xiang from becoming too powerful. In 1936 Liu Wenhui's ties with Chiang soured even further due to his independent policy, but Chiang was not powerful enough to do anything meaningful against him at the time. Liu's relationship had a cooperative relationship with Sichuan governor Zhang Qun, the leader of the KMT's Political Science Clique. Both men being Sichuan natives, Liu was able to appeal to these provincial ties to enlist Zhang's support in negotiations with Chiang. Zhang, for his part, supported Liu as a counterweight to other Sichuanese warlords. In 1939, fighting broke out in Garzê between the officers of the deceased Panchen Lama and Liu Wenhui's army. Liu spread rumors about northern Kham potentially being granted to the Panchen Lama's office by the Kuomintang, and drove out the Lama's men. Although the Panchen Lama's forces were normally KMT-aligned, the central government remained on good terms with Liu Wenhui, who by now had taken advantage of the war against Japan to acquire more funding for Xikang. In January 1947, an anti-Liu uprising led by Zhu Shizheng (朱世正) captured the towns of Lushan and Tianqian and attempted to take Ya'an.
=== Sponsor === Throughout the clinical trial, the sponsor is responsible for accurately informing the local site investigators of the true historical safety record of the drug, device or other medical treatments to be tested, and of any potential interactions of the study treatment(s) with already approved treatments. This allows the local investigators to make an informed judgment on whether to participate in the study or not. The sponsor is also responsible for monitoring the results of the study as they come in from the various sites as the trial proceeds. In larger clinical trials, a sponsor will use the services of a data monitoring committee (DMC, known in the US as a data safety monitoring board). This independent group of clinicians and statisticians meets periodically to review the unblinded data the sponsor has received so far. The DMC has the power to recommend termination of the study based on their review, for example if the study treatment is causing more deaths than the standard treatment, or seems to be causing unexpected and study-related serious adverse events. The sponsor is responsible for collecting adverse event reports from all site investigators in the study, and for informing all the investigators of the sponsor's judgment as to whether these adverse events were related or not related to the study treatment.
== Medical Use == The hydrochloride salt is available as ampoules of 10 mg/ml solution for injection, 5 mg tablets, and 10 mg suppositories. It is possible that other manufacturers distribute 10 mg tablets and other concentrations of injectable nicomorphine in ampoules and multidose vials. It is used, particularly in the German-speaking countries and elsewhere in Central Europe and some other countries in Europe and the former USSR in particular, for post-operative, cancer, chronic non-malignant and other neuropathic pain. It is commonly used in patient-controlled analgesia (PCA) units. The usual starting dose is 5–10 mg given every 3–5 hours.
Although progesterone does not have significant AR-mediated androgenic or antiandrogenic activity, it is a precursor and intermediate, albeit distant, in the biosynthesis of androgens from cholesterol. For this reason, there has been some speculation that exogenous progesterone could be transformed into androgens by certain tissues that express the requisite enzymes. Progesterone is converted by 17α-hydroxylase into 17α-hydroxyprogesterone; 17α-hydroxyprogesterone is converted by 17,20-lyase into androstenedione; and androstenedione is converted by 17β-hydroxysteroid dehydrogenases into testosterone. CYP17A1, the cytochrome P450 gene that encodes 17α-hydroxylase and 17,20-lyase, is expressed mainly in the gonads (ovaries and testes) and the adrenal glands. However, while it is theoretically possible that progesterone could be transformed in the body into androgens, no androgenic effects have been observed in animal studies. In addition, clinical studies, in which women were treated with 100 to 300 mg/day oral progesterone, have found no or only a small increase in levels of 17α-hydroxyprogesterone, and no change in androgen levels, including of dehydroepiandrosterone, androstenedione, and testosterone. In these studies, levels of estradiol and cortisol, which progesterone is also a precursor of, did not change either, although levels of 11-deoxycorticosterone increased significantly.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Solid peptide is best kept frozen at about minus 20 degrees Celsius in a sealed container with desiccant. It should be allowed to reach room temperature before opening to prevent condensation. Repeated warming and cooling of the same vial is discouraged.